To Outset, or Not to Outset
The greater axle track width used with dual wheels would make that same axle too wide when equipped with wide-single tires. Photos: Jim Park
“>
The greater axle track width used with dual wheels would make that same axle too wide when equipped with wide-single tires. Photos: Jim Park
“>
It’s easy enough to slap a wide-single wheel onto a hub where there used to be dual wheels. But there’s a little more to think about when replacing wide-singles with duals. In fact, any tire and wheel modifications from the original spec should be carefully thought through before the torque wrenches come out. There’s more at play here than meets the eye — especially the untrained eye.
In the aftermarket, where professional guidance might not be readily available, one could mistakenly create an overload scenario and reduce the fatigue-life of the wheel bearings, cautions Brandon Uzarek, technical service engineer, field engineering with Accuride Corp.
“It’s important for fleets to be mindful of how the whole wheel end system is integrated, from axle and wheel-end components to the wheel itself,” Uzarek says. “Some fleets are experiencing undue wheel bearing, hub and spindle wear due to the wheel-axle outset mismatch, usually in the aftermarket when replacement wheels are installed. Fleets don’t always contact the axle manufacturer to understand what’s necessary for their application. They could avoid the bearing wear problem if they were aware of its potential causes.”
Upfront, when the truck or trailer is new, owners usually don’t have to worry too much about the wheel-end spec. There are things to consider here, such as suspension and frame clearance and the width of the tires relative to the overall width of the vehicle, but the OEM and the axle/suspension suppliers usually take that into account when approving the spec.
“Historically, trailer suspensions (air or mechanical) were designed to accommodate most wheel offsets and tire combinations, as the suspension was a standalone purchase component,” explains Bill Hicks, director-product planning, Americas, for SAF-Holland. “With …Read the rest of this story
Source:: http://www.truckinginfo.com/channel/equipment/article/story/2017/04/to-outset-or-not-to-outset.aspx